How To Build a Shed | Get Into Gardening

For many people, their shed is not just a place to put tools where you keep The Best Backpack Leaf Blower for 2020, it’s a sanctuary to relax in and think about what to tackle next in the garden. What you use your shed for is up to you, but they make sure it’s built well (and safely), here’s a step-by-step guide: The first thing to do when your shed is delivered, is to check all the bits are included (like screws, hinges, locks, and wood). The next job is to plan what it’s going to be built on. Sheds need to sit on a hard level surface – otherwise, the frame might distort. There are several options to choose from:

  • Treated wooden beams laid over paving or shingle.
  • An interlocking shed base (available with most sheds) laid onto firm ground.
  • Concrete laid on flattened hardcore (rumble). Before you start building your shed, you should treat all of the wooden parts with a preservative – to help it survive the elements. Most sheds are applied a base coat in the factory, but this won’t last forever, so it’s a good idea to top it up. Two extra coats of good quality preservatives in your preferred color should protect all your hard work. Although the individual parts of a shed are not very heavy, they can be awkward for one person to handle.

So call on a friend or neighbor to help. Some sheds come with the floor panel already attached to the joists (which is great). Others will need a bit more work on your part. To assemble the base, the joists need to be laid out under the floor sheet and nailed in. For the exact spacing follow the manufacturer’s guidelines. To make this easier, mark the exact center point of each wall on its bottom edge. Do the same on the shed floor. Then marry these up and they’ll be in the right position on all four sides.While one person supports a panel, use a spirit level to check it’s vertical. Then use a scrap of wood to hold it in place. Then position the next panel next to it and fix together with screws.

NOTE:

Don’t fix the wall panels to the floor until the roof is fitted. Some sheds come with a roof support bar – which needs to be fitted before you try and attach the roof panels. Once this is done, nail the panels in place as per the manufacturer’s instructions. Next roll out the roofing felt from front to back, leaving a 50mm overlap on all sides. Using felt tacks gently hammer this on. You’re then able to add the fascias. To stop them splitting pre-drill them with 2mm holes. This is usually pretty straight forward as most sheds come with grooves for you to slide the plastic or glass frames in.

Patrick

Written by 

Patrick is a part-time fitness trainer and pursuing his Master’s in American Literature from Stanford University. He wishes to share his fitness plan with others to help them achieve their goals in terms of fitness and education.